Manuals / Brands / Computer Equipment / Projector / Sony / Computer Equipment / Projector

Sony FX52L, VPL-FX52 Cleaning the Air, Filter, Disposal of the used lamp, For the customers in the USA

1 57

Download 57 pages, 1.41 Mb

6 Insert the new lamp all the way in until it is securely in place. Tighten the two screws. Fold down the handle.

Notes

• Be careful not to touch the glass surface of the lamp.

• The power will not turn on if the lamp is not secured properly.

• When attaching the lamp, be careful not to overtighten the screws.

7 Close the lamp cover and tighten the screw.

Note

Be sure to attach the lamp cover securely as it was. If not, the projector cannot be turned on.

8 Turn the projector back over.

9 Connect the power cord and turn the projector to standby mode.

10Press the following keys on the control panel in the following sequence for less than five seconds: RESET, <, ,, ENTER.

Caution

Do not put your hands into the lamp replacement spot, or not fall any liquid or object into it to avoid electrical shock or fire.

Disposal of the used lamp For the customers in the USA Lamp in this product contains mercury. Disposal of these materials may be regulated due to environmental considerations. For disposal or recycling information, please contact your local authorities or the Electronic Industries Alliance (www.eiae.org).

Cleaning the Air

Filter

The air filter should be cleaned whenever you replace the lamp.

Remove all traces of dust from the outside of the ventilation holes with a vacuum cleaner.

The time needed to clean the air filter will vary depending on the environment and on how the projector is used.

When it becomes difficult to remove the dust from the filter with a vacuum cleaner, remove the air filter and clean it.

1 Turn off the power and unplug the power cord.

2 Place a protective sheet (cloth) beneath the projector. Turn the projector over so you can see its underside.

3 Slide the air filter cover in the direction of the arrow and remove it.

Maintenance

4 Remove the air filter from the 6 tabs of the air filter cover.

Air filter

Air filter cover

Cleaning the Air Filter 43

Contents

VPL-FX52/FX52L WARNING CAUTION For safety For the customers in Europe For the customers in Taiwan only For the State of California, USA only Table of Contents BOverview Precautions On safety On illumination On cleaning On repacking On installation Notes on Installation and Usage Poorly ventilated Highly heated and humid Subject to direct cool or warm air from an air-conditioner Near a heat or smoke sensor Blocking the ventilation holes Toppling the unit Tilting right/left Placing a blocking object just in front of the lens Features High brightness, high picture quality Convenient and flexible setup Multi scan compatibility Location and Function of Controls aFront remote control detector bLens cLens cover dControl panel lAdjuster mAir filter aLENS CONTROL key bArrow keys (M/m/</,) cIndicators dI / 1 (on / standby) key eINPUT key fAPA (Auto Pixel Alignment) key hENTER key iRESET key aINPUT A connectors (HD D-sub 15-pin,female) bINPUT B connector (RGB (DVI)) (DVI-D) cINPUT C connectors eVIDEO IN connectors fTRIG (trigger output) jack (monaural minijack) gCONTROL S/PLUG IN POWER (DC 5V output) jack (stereo minijack) hRS-232Cconnector (D-sub9- pin, female) iVIDEO OUT connectors e(Memory Stick) key fFREEZE key gAIR SHOT key 8Keys that emulate a mouse iENTER key Battery installation BSetting Up and Projecting Installation Example To calculate the installation measurement (unit: mm) Connecting the Projector When you connect the projector, make sure to: Page To connect to a video GBR/Component equipment Selecting the Menu Language To clear the menu Projecting To input from To mute the picture To get the clearest picture Using the security lock Security certification To cancel the security lock To turn off the power When you cannot confirm the on-screenmessage Direct Power On/Off function On air filter To enlarge the image (Digital Zoom function) To return the image back to its original size To freeze the image projected (Freeze function) BAdjustments and Settings Using the Menu Using the MENU To reset items that have been adjusted About the memory of the settings If no signal is input About the menu display The PICTURE SETTING Menu Picture Mode Adjust Picture When the video signal is input When the RGB signal is input Contrast Brightness The INPUT SETTING Menu Wide Mode Dot Phase H Size Shift Scan Converter The SET SETTING Menu Smart APA Auto Input Search Input-CSignal Sel Color System The MENU SETTING Menu The INSTALL The INFORMATION Menu Lamp Timer IP Address Subnet Mask BOperation and Administration using a Network Accessing the Projector from a Computer Checking the Status of the Projector Click “Information.” INFORMATION MENU Controlling the Projector from a Computer Click “Control.” Setting Up the Projector Click “Setup.” Setting the date and time Network Settings Settings for the Mail Report function Report Timing field Address field Mail Account field Advanced setting BMaintenance Replacing the Lamp Cleaning the Air Filter Page Troubleshooting Power Picture Remote Commander Warning Messages Caution Messages BOthers Specifications Optical characteristics Electrical characteristics Input/Output General Optional accessories Pin assignment Input signals and adjustable/ setting items Preset signals Page Index Numerics