Symptom

Cause and Remedy

 

 

The picture from INPUT C

• Setting for Input-C Signal Sel. in the SET SETTING menu is

connector is colored

incorrect.

strange.

c Select Computer, Video GBR or Component for Input-C Signal

 

Sel. in the SET SETTING menu according to the input signal

 

(see page 34).

 

 

“Please check INPUT-C

• Setting for Input-C Signal Sel. in the SET SETTING menu is

setting.” appears in spite of

incorrect.

inputting the correct signal

c Select Computer, Video GBR or Component for Input-C Signal

from INPUT C.

Sel. in the SET SETTING menu according to the input signal

 

(see page 34).

 

 

On-screen display does not

• Status in the MENU SETTING menu has been set to Off.

appear.

c Set Status in the MENU SETTING menu to On (see page 35).

 

 

Color balance is incorrect.

• Picture has not been adjusted properly.

 

c Adjust the picture (see page 31).

 

• Projector is set to wrong color system.

 

c Set Color System in the SET SETTING menu to match the color

 

system being input (see page 34).

 

 

The picture is too dark.

• Contrast or Brightness has not been adjusted properly.

 

c Adjust the Contrast or Brightness in the PICTURE SETTING

 

menu properly (see page 31).

 

• The lamp has burnt or dims.

 

c Replace the lamp with a new one (see page 42).

 

 

The picture is not clear.

• Picture is out of focus.

 

c Adjust the focus (see page 24).

 

• Condensation has occurred on the lens.

 

c Leave the projector for about two hours with the power on.

 

 

The image extends beyond

• The APA key is pressed although there are black edges around the

the screen.

image.

 

c Display the full image on the screen and press the APA key.

 

c Adjust Shift in the INPUT SETTING menu properly (see

 

page 33 ).

 

 

The picture flickers.

• Dot Phase in the INPUT SETTING menu has not been adjusted

 

properly.

 

c Adjust Dot Phase in the INPUT SETTING menu properly

 

(page 33).

 

 

Remote Commander

Symptom

Cause and Remedy

 

 

The Remote Commander

• The Remote Commander batteries are dead.

does not work.

c Replace with a new battery (see page 16).

 

 

The menu display does not

• The PJ/NETWORK select switch on the Remote Commander is

appear even when you

set to NETWORK.

press the MENU key on the

c Set the PJ/NETWORK select switch to PJ, then press the

Remote Commander.

MENU key.

 

 

46 Troubleshooting