9 Slide the top cover back until it makes contact with the rear side.
10 Tighten the screw (single long screw (M3)) in the bottom base.
Note
•The lens scratches easily, so when handling it, always place it gently on a stable and level surface in a horizonal position.
•Avoid touching the lens surface.
For rear projection, you can set the optical axis angle to 0 (zero). In this case, you will need to set the lens position as follows.
You can install the following types of lenses for a zero optical axis angle.
•Standard lens
•
•
1 Turn off the power and disconnect the power cable.
2 Remove the screw from the bottom of the unit by using a Philips screwdriver .
(single long screw (M3))
3 Slide the top cover (top lens cover) forward, and then lift it up to remove.
4 Remove the lens hood locking the lens by loosening the four screws (M3⋅10, with washers) with a Philips screwdriver.
14