Location and Function of Controls

Connector panel

Left side

56

CONTROL S IN

VIDEO IN

PLUG IN POWER

S VIDEO VIDEO

TRIGGER

INPUT A

4 1

G/Y

B/CB/PB R/CR/PR SYNC/HD VD

REMOTE

INPUT B

3 2

RS-232C

G/Y B/CB/PB R/CR/PR SYNC/HD VD

(FOR SERVICE USE)

 

1INPUT A connectors

G/Y, B/CB/PB, R/CR/PR, SYNC/HD, VD connectors (phono type):

Connect to the RGB output of the equipment. According to the connected equipment, computer, component (Y/CB/CR), HDTV or DTV (DTV GBR, DTV YPBPR) signal is selected.

2INPUT B connectors

G/Y, B/CB/PB, R/CR/PR, SYNC/HD, VD connectors (phono type):

Connect to the RGB output of the equipment. According to the connected equipment, computer, component (Y/CB/CR), HDTV or DTV (DTV GBR, DTV YPBPR) signal is selected.

3RS-232C connector (D-sub 9-pin, female) This is a service connector.

4TRIGGER connector (minijack)

Outputs the ON or OFF condition of the unit to the external equipment.

When the unit is turned off, 0 V is output and when the unit is turned on, 12 V is output. However, as power is not output, you cannot use the connector as a power source.

5CONTROL S IN/PLUG IN POWER (DC 5V output) jack

Connects to the control S out jacks of the Sony equipment. Connects to the CONTROL S OUT jack on the supplied Remote Commander when using it as a wired Remote Commander. In this case, you do not need to install the batteries in the Remote Commander, since power is supplied from this jack.

If this connector is used, the Remote Commander key lamp is not turned on.

6VIDEO IN jacks

Connect to external video equipment such as a VCR. S VIDEO (mini DIN 4-pin):Connects to the S video

output (Y/C video output) of video equipment. VIDEO (phono type): Connects to the composite

video output of video equipment.

12 (GB)