Close the lamp cover and tighten the screw. Turn the projector back over.

6

7

8 Connect the power cord and turn the projector to the standby mode.

9 Press the following keys on the control panel in the following order for less than in five seconds each: RESET, <, ,, ENTER.

Notes

•Do not put your hands into the lamp replacement spot, or not fall any liquid or object into it to avoid electrical shock or fire.

•Be sure to use the LMP-P200 Projector Lamp for replacement. If you use lamps other than LMP-P200, the projector may cause a malfunction.

•Be sure to turn off the projector and unplug the power cord before replacing the lamp.

Disposal of used projector lamp

As the materials used in this lamp are similar to those of a fluorescent lamp, you should dispose of a used projector lamp in the same way as a fluorescent lamp.

Cleaning the Air Filter

The air filter should be cleaned every 300 hours.

When it becomes difficult to remove the dust from the filter, replace the filter with a new one.

To clean the air filter, follow the steps below:

1 Turn off the power and unplug the power cord.

2 While pressing the triangle mark on the air filter cover, slide and remove the air filter cover (at the bottom of the projector).

Maintenance

3 Pull up the spring.

4 Remove the air filter.

5 Remove the dust from the filter with a vacuum cleaner.

6 Attach the air filter and replace the cover.

Notes

•If the air filter is excessively dirty, wash it with a mild detergent solution and dry it in a shaded place. If the dust cannot be removed, replace the air filter with the supplied new one.

•Be sure to attach the air filter cover firmly; the power will not be turned on if it is not closed securely.

Maintenance

35 (GB)