Screen Menu
The Screen menu is used to adjust the input signal. You can adjust the size of the picture, and select wide screen mode, etc.
.
Wide Mode (When the You can set the aspect ratio of the picture to be displayed for the image input signal is current input signal. This item is enabled only when an image signal
input)(preset memory numbers 1 to 14) (1 page 73, 74) is input.
Wide Zoom: A 4:3 aspect ratio picture is enlarged over the entire screen properly. The upper and lower portions of the screen are slightly cut off.
Normal: A picture with normal 4:3 aspect ratio is displayed in the center of the screen to fill the vertical screen size.
Full: A picture squeezed to 4:3 is displayed with the correct aspect ratio. A 4:3 picture is enlarged horizontally to fit the 16:9 screen.
Zoom: A normal 16:9 aspect ratio picture is enlarged vertically and horizontally in the same ratio to fill the screen.
Anamorphic Zoom: A 2.35:1 aspect ratio picture is converted to a normal 16:9 picture on the screen. This mode is best suited when using a commercially available Anamorphic lens which converts a normal 16:9 aspect ratio picture to a 2.35:1 picture.
Wide Mode (When the You can set the aspect ratio of the picture to be displayed for the
PC signal is input) current input signal. This item is enabled only when an PC signal is input.
Full1: Displays a picture on the whole of the screen without changing the aspect ratio of the original picture.
Full2: Displays a picture on the whole of the screen.
Zoom: A normal 16:9 aspect ratio picture is enlarged vertically and horizontally in the same ratio to fill the screen.
Over Scan | Hides the outline of the picture. |
|
| On: Hides the outline of the input picture. Select this setting when noise | |
| appears along the edge of the picture. |
|
| Off: Projects the whole of the input picture. | |
| Tip |
|
| To display the displayable region within the four directions of the screen, | |
| refer to “Blanking” on the Installation | |
46