Symptom | Cause and Remedy |
The picture flickers. c Activate “APA”, then adjust the current input signal.
cAdjust “Phase” for “Adjust Signal” in the Screen 
menu properly. (1 page 47)
The color of characters or c Select the desired color registration in “Panel Alignment” of
the picture is notInstallation 
menu (1 page 53). appropriate.
On-screen display
Symptom | Cause and Remedy |
|
|
|
|
c Set “Status” in the Setup | ||
appear. | c Check if the ?/1 (ON/STANDBY) indicator should light in | |
| green. |
|
|
| |
The model name does not | c The display mode of the projector may be set at the time of | |
disappear from the screen. | purchase. Consult with your local dealer or qualified Sony | |
| personnel. |
|
|
|
|
Remote control
Symptom | Cause and Remedy |
|
|
|
| ||
The remote control does | c Batteries could be weak. Replace them with new batteries. | ||
not work. |
|
| |
| c Insert the batteries with the correct polarities. (1 page 11) | ||
| c In the Installation | menu, set the setting of “IR Receiver” to | |
|
| ||
| c If there is a fluorescent lamp near the remote control detector, the | ||
| projector may work improperly or inadvertently. Change the | ||
| setting of “IR Receiver” in the Installation | ||
|
|
|
|
Others
Symptom | Cause and Remedy |
|
The fan is noisy. | c Check the setting of “Cooling Setting” in the Setup | menu. |
|
|
cMake sure that the room temperature is not too high.
cCheck the installation conditions. (1 page 12)
The number of fan rotation increases to maintain the product reliability of the projector’s components in a room, where the temperature is higher than normal. The fan noise becomes slightly louder. The approximate normal temperature is 25°C.
Image is left on the screen. c When High contrast
(image retention)long period of time, there may be some image retention on the screen. This is only a temporary condition. Turning off the power for a while will eliminate the retained image.
Others
61