Installation Menu
The Installation menu is used for changing the installation settings.
V Keystone | Corrects the vertical trapezoidal distortion of the picture. |
| ||
| When the bottom of the trapezoid is longer than the top ( | ): | ||
|
| Sets a lower value (– direction) |
| |
| When the top of the trapezoid is longer than the bottom ( | ): | ||
|
| Sets a higher value (+ direction). |
| |
|
|
|
|
|
|
| Note |
| |
| Depending on the picture position adjusted with the lens shift |
| ||
| feature, the aspect ratio of the picture may change from the original | |||
| or picture distortion may occur with V Keystone adjustment. |
| ||
|
|
|
|
|
Image Flip | Flips the picture on the screen horizontally and/or vertically. |
| ||
| Off: The picture does not flip. |
| ||
| HV: Flips the picture horizontally and vertically. |
| ||
| H: Flips the picture horizontally. |
| ||
| V: Flips the picture vertically. |
| ||
| Use this item for installation for the backside projection or ceiling |
| ||
| installation. |
| ||
|
|
|
|
|
Lens Control | Avoids any operation of the lens such as “Lens Focus,” “Lens |
| ||
| Zoom,” and “Lens Shift,” by mistake. |
| ||
| When set to “On,” you can adjust the projection lens using “Lens |
| ||
| Focus,” “Lens Zoom,” and “Lens Shift.” After you make this |
| ||
| adjustment, it is recommended that you set this item to “Off” to |
| ||
| avoid any operation of the lens. |
| ||
|
|
|
|
|
IR Receiver | Selects the remote control detectors (IR Receiver) on the front |
| ||
| and rear of the projector. |
| ||
| Front & Rear: Activates both the front and rear detectors. |
| ||
| Front: Activates the front detector only. |
| ||
| Rear: Activates the rear detector only. |
| ||
|
|
|
|
|
Illumination | Selects whether the illumination on the top panel of the |
| ||
| projector lights when the projector is on. |
| ||
| Turns on the illumination on the top panel of the projector, when set | |||
| to “On.” It turns off when set to “Off.” |
| ||
|
|
|
|
|
52