Message Lists

Warning messages

Message

Cause and Remedy

 

 

 

 

 

 

High temp.! Lamp off in 1

 

c Turn off the power.

 

min.

 

c Check to ensure that nothing is blocking the ventilation holes.

 

 

(1 page 13)

 

 

 

 

 

Frequency is out of range!

 

c Frequency is out of range. Input a signal that is within the

 

 

acceptable frequency range of the projector.

 

 

 

 

 

 

Please check Input-A

 

c Set “Input-A Signal Sel.” in the Setup

menu to

Signal Sel.

 

“Computer” when an RGB signal is input from a computer.

 

 

(1 page 49)

 

 

 

 

 

Please replace the Lamp/

 

c The remaining available usage time for the lamp and the air

Filter.

 

filter is short. (Estimated approximately 50 hours.)

Lamp/Filter life remains

 

 

 

 

 

Note

 

 

less than 50H.

 

 

 

To clear the message on the screen, press any key on the remote

 

 

control or the control panel of the projector once.

 

 

 

 

Please replace the Lamp/

 

c The remaining available usage time for the lamp and the air

Filter.

 

filter is short. (Estimated approximately 15 hours.)

Lamp/Filter life remains

 

 

 

 

 

Note

 

 

less than 15H.

 

 

 

To clear the message on the screen, press any key on the remote

 

 

control or the control panel of the projector once.

 

 

 

 

Please replace the Lamp/

 

c It is time to replace the lamp. Replace the lamp. (1 page 65)

Filter.

 

c Also, replace the air filter too. (1 page 65)

End of Lamp/Filter life.

 

If the message appears again after you replace the lamp and the

Lamp off in 1 min.

 

air filter, the lamp replacement process is not complete. Check

 

 

the lamp replacement process. (1 page 65)

 

 

 

 

 

Please clean the filter.

 

c It is time to clean the air filter. Clean the air filter. (1 page 70)

 

 

 

 

 

 

 

Note

 

 

To clear the message on the screen, press any key on the remote

 

control or the control panel of the projector once.

 

 

 

 

Please clean the filter. Have

 

c It is time to clean the air filter. Clean the air filter. (1 page 70)

you finished? Yes No

 

c If you cleaned the air filter, select “Yes.” If you did not clean the

 

 

air filter, select “No.”

 

 

 

 

 

Projector temperature is

 

c Check to ensure that the Ventilation holes on the unit are not

high. Cooling Setting

 

covered. (1 page 13)

 

should be “High” if

 

c When using the projector at high altitude, set the Cooling

projector is being used at

 

Setting to “High”. (1 page 48)

 

high altitude.

 

 

 

 

 

Note

 

 

 

 

 

 

 

When temperature inside the projector remains high, the Cooling

 

Setting is switched to “High” in one minute, then the fan speed

 

increases.

 

 

 

 

 

 

Others

63