Sony Ericsson SCA 3602 M4 manual Position Set the switch, Manual flash mode M

705 47 0025.A2-GB,I,E 20.02.2008 15:48 Uhr Seite 10

and 70 MZ-... TTL flash control is an automatic flash mode where flash exposure is measured by a sensor built into the camera. In principle, the TTL flash mode with a Sony digital camera is a partial- light-output related GN mode with preflash mete- ring, where one or more pre-flashes are fired a fraction of a second before the picture is shot. The TTL flash control is supported by all camera modes (e.g. P, A, S, M).

☞The TTL flash mode of Sony digital cameras must not be mistaken with the standard TTL flash control of analog cameras! We therefore recommend that the secondary reflector of the flash unit (e.g. 45 CL-4, 50 MZ-5,

54 MZ-..., 70 MZ-5) is not activated. The Metz Remote TTL Mode is not supported on account of the pre-flash system.

Settings:

•Switch the flash unit to TTL mode (see operating instructions for the given flash unit).

• Set the SELECT switch		of the adapter in the
“B” position.
• Set the switch	of the adapter in the “GN”
position.

☞The RED-EYE REDUCTION preflash function is supported by the above flash units.

3.1.3 Manual flash mode M

The mecablitz always emits the same defined amount of light. Depending on the mecablitz model, full light output or partial light output levels can be chosen. The Winder („W“) or Stroboscopic Mode are partial light output levels.

10