9SERIAL connector
You can connect a serial cable to this connector to control a camera from a camera control device (e.g., PC).
Pin No. | Signal | Pin No. | Signal |
1 | TXD | 4 | ISO input + |
|
|
|
|
2 | RXD | 5 | ISO input – |
|
|
|
|
3 | Ground | 6 |
q; LAN connector
You can connect a LAN cable to this connector to output a video signal to the host device.
Pin No. | Signal | Pin No. | Signal |
|
|
|
|
1 | TD+ | 5 | NC |
|
|
|
|
2 | TD– | 6 | RD– |
|
|
|
|
3 | RD+ | 7 | NC |
|
|
|
|
4 | NC | 8 | NC |
|
|
|
|
qa MODE switches
For service use. Both switches are set to the left side as the factory setting.
Note
If either of these switches is set to the right side, the camera doesn’t start normally.
qs POWER LED
Lights in green when power is input.
qd STATUS LED
Lights in red when the BIOS is starting up.
qf RESET switch
Push to restart the camera.
Overview
Connecting the cables
7 | 6 | 1 |
|
| 2 |
|
| 3 |
q; 8 | 9 | 4 |
| ||
|
| 5 |
1 Monitor cable |
| 6 MONITOR connector |
2 USB cable |
| 7 USB connector |
3 LAN cable |
| 8 DC IN connector |
4 Camera cable |
| 9 SERIAL connector |
5 Serial cable |
| 0 LAN connector |
Connect the camera cable to the DC IN connector. Also, if needed, connect the LAN cable to the LAN connector, the monitor cable to the MONITOR connector, the serial cable to the SERIAL connector, and the USB mouse/keyboard to the USB connector respectively.
When you connect the monitor cable, turn the two fastening screws to secure the cable tightly.
Connect the other end of the camera cable to the DC- 700/700CE. Also, if needed, connect the LAN cable to the host device, and the monitor cable to the monitor, and the serial cable to the camera control device.
Note
Make sure to supply power to the camera module and confirm that the camera module is operating before inputting a trigger signal. If you input external signals to a camera module without the power supplied, this may cause a malfunction of the camera module.
7