Southbend HDG-48-M, HDG-60-M, HDG-72-RE, HDG-36-RE, G-72-M, HDG-36-M Owner ’S Manual 1182845 REV

	INSTALLATION	HEAVY DUTY COUNTERLINE
	Figure 9
	J	K
	I	I
INSTALLATION	H
		J
		L
	N	L
	O	M

7.Check the partially assembled stand to make sure that the legs are straight and that all corners are square. Now tighten all bolts, but do not over tighten.

8.If legs with casters were ordered, lift the stand and screw the caster assemblies into the bottom of the legs. The two casters with wheel-locks go on the front legs. After the stand is assembled, be sure to connect the required restraint to protect the flexible gas connection (see Step 3 on page 17).

9.If the optional shelf was ordered (item “K”), position it on top of the bottom braces. The down-flange edge of the shelf should be on the front side of the stand. The shelf simply rests on the bottom braces (it is not bolted or screwed to the braces).

10.Position the front and rear top supports (items “L”) over the legs. The pre-drilled holes should face the outside of the stand to line up with the threaded-insert holes near the top of the legs. Use the four 5/8" hex-head bolts (items “M”) to secure the top supports to the legs.

11.Attach the angle support brackets (item “N”, shipped with the appliance) to the bottom of the of the appliance using #10x1/2" sheet metal screws (item “O”, also shipped with the appliance).

12.Place the appliance on top of the stand, making sure that the angle brackets that you just installed on the bottom of the appliance are inserted into the front and rear top supports. No additional bolts or screws are required. Lift the appliance only at the ends, never in the middle!

13.Go on to Step 4 on page 18.

PAGE 14 OWNER’S MANUAL 1182845 REV 8