Model SB1018 | E L E C T R I C A L | For Machines Mfg. Since 8/09 |
220V Conversion
Wiring diagrams are provided in this section showing the Model SB1018 wired for both 110V and 220V. Refer to these diagrams if needed when following this procedure. Additionally, you must purchase a 220V switch (Part
No. PSB1018204) in order to complete the conversion.
Items Needed | Qty. |
220V Switch (Part No. PSB1018204) | 1 |
Phillips Screwdriver #2 | 1 |
Wrench 18mm | 1 |
Wire nut (sized for three 14 Ga. wires) | 1 |
Electrical Tape | As needed |
Wire stripper | As needed |
To convert the Model SB1018 to 220V:
1.DISCONNECT BANDSAW FROM POWER!
2.Open the motor junction box, then loosen the wire terminals indicated in Figure 53. Re- move the wires connected to those terminals.
3.Use a wire nut to connect wires #2, #3, and #5, then wrap the wires and nuts with elec- trical tape.
4.Connect wires #1 and #6 to the upper right terminal and wire #4 to the lower right terminal shown in Figure 54. Tighten the terminal screws to secure the wires.
art |
|
| 220V |
citor |
|
| |
MFD |
|
| Wiring |
VAC |
|
| |
|
|
| |
3 | 5 |
| OVERLOAD |
2 |
| 1 | RESET |
|
| G | |
|
|
| |
|
| 6 |
|
4 |
Tighten These |
GND Terminal Screws |
Figure 54. Rewired for 220V.
5.Close the motor junction box and secure the cover with the provided screw.
t
itor 
FD AC
| OVERLOAD |
|
1 | RESET |
|
| GND | |
| 3 | |
|
| |
| 6 |
|
| 4 |
|
| 2 | 110V Wiring |
| 5 | |
| Loosen These | |
|
| |
| GND | Terminal Screws |
Figure 53. Wiring terminal locations.
6.Use the 18mm wrench to remove the four hex bolts that secure the machine to the cabinet, then with the help of another per- son, remove the machine from the cabinet. Carefully place the machine on its side to gain access to the underside of the base.
7.Remove the black plastic switch cover from behind the switch. Disconnect the two wires from the back of the switch, then remove the switch.
8.Install the 220V switch, then replace the two wires removed in Step 7 in the correspond- ing locations from which they were removed.
9.Replace the switch cover, then with the help of another person, place the machine back onto the cabinet and secure it with the hex bolts removed in Step 6.
READ PAGE 41 BEFORE
DOING ANY WIRING!
