Southbend sb1018 owner manual Assembly, To assemble the bandsaw

For Machines Mfg. Since 8/09 P R E P A R A T I O N Model SB1018

Assembly

To assemble the bandsaw:

1.Attach the left and rear panels and the bottom shelf together as shown in Figure 9 with three M8-1.25 x 15 hex bolts, three M8- 1.25 hex nuts, and six 8mm flat washers.

4.Install the shelf in the stand assembly as shown in Figure 11 with (2) M8-1.25 x 15 hex bolts, (2) M8-1.25 x 15 flat head screws,

(4) M8-1.25 hex nuts, and (6) 8mm flat washers.

Left Panel

x3

Rear Panel

Bottom Shelf

x2

x2

Top View

Figure 11. Shelf installation.

Figure 9. Left and rear panel assembly.

2.Attach the front panel in the same manner as Step 1.

3.Attach the right panel to the stand assembly as shown in Figure 10 with four M8-1.25

x 15 hex bolts, four M8-1.25 hex nuts, and eight 8mm flat washers.

Right Side Panel	Stand
	Assembly

x4

5.Install the handle with four M8-1.25 x 40 hex bolts, eight 8mm flat washers and four M8-1.25 hex nuts as shown in Figure 10.

x4

Figure 12. Handle installation.

6.Carefully place the stand assembly upside down.

Figure 10. Right panel assembly.

-15-