For Machines Mfg. Since 8/09 | M A I N T E N A N C E | Model SB1018 |
Gearbox |
|
Items Needed | Qty |
Wrench 4mm | 1 |
Mobil Spartan EP220 or ISO 220 EP Equivalent | |
Gear Oil | Approximately 1 Pint |
Handheld Oil Pump | 1 |
Shop Rags | As needed |
Wooden Blocks | As needed |
To change the gearbox oil:
1.DISCONNECT BANDSAW FROM POWER!
2.Loosen the four hex bolts that secure the machine to the cabinet.
3.With the help of another person, carefully remove the saw from the stand and place it on a workbench. Use wooden blocks to support the machine so that the gearbox cover is horizontal, as shown in Figure 44.
! |
Hex Bolts |
Downfeed |
Ram Bracket |
Gear Box |
Cover |
Gear Box |
Figure 44. Gear box location.
Make sure the machine is sufficiently supported and stable so that it will not shift during this procedure.
4.Remove the four hex bolts that secure the gearbox cover, then remove the gearbox cover and downfeed ram bracket.
5.Use a handheld oil pump to draw the oil out of the gearbox, then use a rag to remove any remaining oil and debris.
6.Add oil to the gearbox until it is approximately half full, then replace the gearbox cover.
Machine Storage
All machinery will develop serious rust problems and corrosion damage if it is not properly prepared for storage. If decommissioning this machine, use the steps in this section to ensure that it remains in good condition.
To prepare your machine for storage or decommission it from service:
1.DISCONNECT BANDSAW FROM POWER!
2.Thoroughly clean all unpainted, bare metal surfaces, then coat them with a light weight grease or rust preventative. Take care to ensure these surfaces are completely covered but that the grease or rust preventative is kept off of painted surfaces.
If the machine will be out of service for only a short period of time, use a quality medium- weight machine oil (not auto engine oil) in place of the grease or rust preventative.
3.Loosen or remove the belt and the blade so they do not stretch while the machine is stored.
4.If the machine will be out of service for only a short period of time, start the machine once a week and run all
If it will be out of service for a long period of time, drain, then completely fill the gearbox with the recommended gear oil so components above the normal oil level do not develop rust. (Make sure to put a tag on the controls as a reminder for the re- commissioning process to adjust the gear oil level before starting the machine.)
5.Completely cover the machine with a tarp or plastic sheet that will keep out dust and resist liquid or moisture. If machine will be stored in/near direct sunlight, use a cover that will block the sun's rays.
