For Machines Mfg. Since 8/09 | P R E P A R A T I O N | Model SB1018 |
Test Run
After all preparation steps have been completed, the machine and its safety features must be tested to ensure correct operation. If you discover a problem with the operation of the machine or its safety components, do not operate it further until you have resolved the problem.
Note: Refer to Troubleshooting on Page 38 for solutions to common problems that may occur with
To test run your machine:
1.Read and follow the safety instructions at the beginning of the manual, take the re- quired safety precautions, and make sure the machine is set up properly.
2.Clear away all tools and objects used during assembly and preparation.
3.Open the downfeed valve (Figure 23) and allow the headstock to travel all the way down. If the blade contacts the machine base, adjust the downfeed stop bolt as described in Downfeed Stop Bolt, on Page 37.
Downfeed
Valve
Figure 23. Downfeed valve location.
4.Connect the machine to the power source.
5.Put on safety glasses and secure loose clothing or long hair.
6.Lift the headstock by the handle to the raised position, then close the downfeed valve to prevent it from lowering.
7.Start the bandsaw while keeping your finger near the ON/OFF switch at all times during the test run. The bandsaw should run smoothly with little or no vibration.
—If you suspect any problems, immediately turn the bandsaw OFF, disconnect it from power, and correct the problem before continuing.
—If you need any help with your bandsaw call our Tech Support at (360)
8.Open the downfeed valve to lower the saw through its full range of motion. When it reaches the bottom of its travel, it should turn OFF. If it does not, manually turn it OFF, disconnect it from power, then re- adjust the
Inspections &
Adjustments
The following list of adjustments were performed at the factory before your machine was shipped. If you find that the adjustments are not set according to the procedures in this manual or your personal preferences,
•Blade Tracking ...................................Page 34
•Squaring the Blade ............................Page 35
•Blade Guide Bearings ........................Page 35
