For Machines Mfg. Since 8/09 | P R E P A R A T I O N | Model SB1020 |
Test Run
After all preparation steps have been completed, the machine and its safety features must be tested to ensure correct operation. If you discover a problem with the operation of the machine or its safety components, do not operate it further until you have resolved the problem.
Note: Refer to Troubleshooting on Page 34 for solutions to common problems that may occur with
To test run your machine:
1.Read and follow the safety instructions at the beginning of the manual, take the re- quired safety precautions, and make sure the machine is set up properly.
2.Clear away all tools and objects used during assembly and preparation.
3.Open the downfeed knob (see Figure 12) and allow the headstock to travel all the way down. If the blade contacts the machine base, adjust the downfeed stop bolt as described in Downfeed Stop Bolt, on Page 39.
Downfeed
Knob
Figure 12. Downfeed valve location.
4.Put on safety glasses and secure loose clothing or long hair.
5.Lift the headstock to the raised position, then close the downfeed knob to prevent it from lowering.
6.Start the bandsaw, but keeping your finger near the emergency stop button at all times during the test run. The bandsaw should run smoothly with little or no vibration.
—If you suspect any problems, immediately turn the bandsaw OFF, disconnect it from power, and correct the problem before continuing.
—If you need any help with your bandsaw call our Tech Support at (360)
7.Open the downfeed knob to lower the saw through its full range of motion. When it reaches the bottom of its travel, it should turn OFF.
—If it does, Congratulations! The test run is complete.
—If it does not, turn it OFF, disconnect it from power, then proceed immediately to Limit Switches, on Page 38.
Inspections &
Adjustments
The following list of adjustments were performed at the factory before your machine was shipped. If you find that the adjustments are not set according to the procedures in this manual or your personal preferences,
•Squaring Blade ..................................Page 40
•Blade Guides ......................................Page 28
