INSTALLATION
INSTALLATION | SEZ SERIES COUNTERTOP STEAMERS |
Step 4: Water Connection
!WARNING
Do not connect steamer to a hot water line. A hot water connection will damage the steamer.
NOTICE
To meet warranty requirements, the supply water must meet the following specifications:
Pressure | 30 to 60 PSI |
Total Dissolved Solids (TDS) | 60 PPM |
Hardness | 2 grains or 35 PPM |
pH | 7.0 to 7.5 |
Connect a cold water line to the water inlet strainer on the back of the steamer, as shown in Figure 4 on page 9. The connector on the unit is 1/4" NPT male.
NOTE: To facilitate cleaning, and allow access to rear of unit, flexible connections are recommended. A shut off valve at (or near) the rear of the unit is highly recommended. See Figure 5 below.
Figure 5 |
|
|
Cold |
|
|
Water |
| Steamer |
Supply |
|
|
Shut Off | Filter | Check |
Valve |
| Valve |
PAGE 10 | OPERATOR’S MANUAL 1183437 |
