TROUBLESHOOTING
TROUBLESHOOTING | SEZ SERIES COUNTERTOP STEAMERS |
Figure 17 |
|
Pressure Switch Check |
|
| SWITCH DETAIL |
| COM |
| NO |
| NC |
Pressure Switch |
|
| Float Control Box |
1.DISCONNECT POWER AT CIRCUIT BREAKER.
2.Remove rear cover.
3.Remove wires B40 and B42 from pressure switch “COM” and “NO” terminals.
4.Open door.
5.Place test leads on “COM” and “NO” terminals as shown.
6.Check continuity. There should NOT be continuity. Replace as necessary.
7.Remove pressure switch from lid.
8.With test leads on “COM” and “NO” terminals as before, gently blow into pressure port and check continuity. There SHOULD be continuity. Replace as necessary.
PAGE 34 | OPERATOR’S MANUAL 1183437 |
