Southbend SEZ/3 manual Troubleshooting KEY, Troubleshooting Figures and Procedures

TROUBLESHOOTING SEZ SERIES COUNTERTOP STEAMERS

TROUBLESHOOTING

This section contains a troubleshooting key and referenced flowcharts to assist a qualified service technician in the servicing of an SEZ Series Countertop Steamer. Please note that the unit has a “SERVICE

REQUEST” light that illuminates in the event of certain water supply problems. Also note that when the unit is turned on, there is a four-minute time delay before the heating elements come on to allow time for filling. Therefore, some procedures call for a waiting period when reconnecting power to the unit or turning the unit on.

TROUBLESHOOTING KEY

Find the symptom below that corresponds to the malfunction, then turn to the corresponding figure and page. Follow the flowchart on that page until the problem is solved.

Symptom	Page
Unit Not Heating Up, “ON” Light Not Lit	19
Unit Not Heating Up Properly or Not Cooking Properly, “ON” Light Lit	20
Excessive Steam Coming from Pressure Relief Vent	21
“Service Request” Light Comes On During Operation	22
Buzzer Does Not Come On	23

TROUBLESHOOTING FIGURES AND PROCEDURES

	Figure and/or Procedure	Page
	Voltage Check at Control Panel Fuse Block	24
	Heating Element Resistance Check (at Contactor)	25
	Main Fuse Replacement	26
	Power Switch Continuity Check	27
	Contactor and MOV Check	28
	Timer and Buzzer Check	29
	Door Switch Continuity Check	30
	Float Switch Continuity Check	31
TROUBLESHOOTING	Controller Check	32
	Water Solenoid Check	33
	Pressure Switch Check	34
	High-Limit Thermostats Check	35
	Electric Schematic for 208, 220, and 240 Volt Model SEZ/3	36
	Electric Schematic for 480 Volt Model SEZ/3	37
	Electric Schematic for 208, 220, and 240 Volt Model SEZ/5	38
	Electric Schematic for 480 Volt Model SEZ/5	39

PAGE 18 OPERATOR’S MANUAL 1183437