STRATOSTEAM COUNTERTOP STEAMER

INSTALLATION

STEP 2A: ATTACH LEGS

A set of four legs is packed with steamers ordered with legs.

A threaded hole is located at each corner. Each leg has a corresponding mating thread. The legs can be adjusted to overcome a slightly uneven surface.

1.Raise the steamer sufficiently to allow the legs to be attached. For safety, “shore up” and support the steamer with an adequate blocking arrangement strong enough to support the load.

2.Screw the legs into the holes (see Figure 4). Note that the front legs are different than the rear legs.

3.Lower the steamer gently onto a level surface. Never drop or allow the steamer to fall.

4.Make sure that the steamer is level (both side-to-side and front-to-back). If necessary, adjust the height of each leg by turning the foot-pad of the leg.

5.Go on to Installation Step 3.

Figure 4

Attach Legs

OWNERS MANUAL 1185184

PAGE 13 OF 48

Page 13
Image 13
Southbend STRE-3D owner manual Attach Legs