![](/images/new-backgrounds/1090917/9091727x1.webp)
INSTALLATION | STRATOSTEAM COUNTERTOP STEAMER |
STEP 2A: ATTACH LEGS AND BRACKETS
A set of four legs is packed with steamers ordered with legs.
A threaded hole is located at each corner. Each leg has a corresponding mating thread. The legs can be adjusted to overcome a slightly uneven surface.
1.Raise the steamer sufficiently to allow the legs to be attached. For safety, “shore up” and support the steamer with an adequate blocking arrangement strong enough to support the load.
2.Screw the legs into the holes (see Figure 5). Note that the front legs are different than the rear legs.
3.Lower the steamer gently onto a level surface. Never drop or allow the steamer to fall.
4.Make sure that the steamer is level (both
5.Go on to Installation Step 3.
Figure 5
Attach Legs and Brackets
STEP 2B: MOUNTING ON CABINET BASE
If the steamer is to be mounted on the optional cabinet base, first attached the legs to the cabinet base (if not already attached). Then place the steamer on top of the cabinet base and line up the threaded holes on the bottom of the steamer with the holes in the
STEP 2C: STACKING TWO STEAMERS
If two steamers are to be stacked, mount the lower steamer first on either legs (Step 2a) or the optional cabinet base (Step 2b). Remove (if present) the four
PAGE 14 OF 44 | OWNER’S MANUAL 1185184 |