7.Pressing Press the
ESC will not save your information and exits to the previous mode.
HOME key at any programmed position to delete that programmed pattern.
NOTE: If total recording time reaches 240 seconds, it will automatically stop for a moment and restart recording. Previous data will be overwritten.
3.9Alarm (This menu shows on only specific model, Fifth Item of Main menu)
|
| ALARM SETUP |
|
| ||
NO PRI PRS IN | OUT HLD LATCH | |||||
01 | 1 | 001 | OFF | OFF | 3 | OFF |
02 | 0 | A01 | OFF | OUT1 3 | OFF | |
03 | 1 | 240 | NO | OUT1 3 | OFF | |
04 | 2 | 001 | NC | OUT4 3 | OFF | |
05 | 1 | 001 | OFF | OFF | 3 | OFF |
06 | 8 | 001 | OFF | OUT1 3 | OFF | |
07 | 1 | 240 | NO | OUT1 3 | OFF | |
08 | 2 | 001 | NC | OUT4 3 | OFF | |
SAVE AND EXIT(ESC TO CANCEL)
NO | : Alarm input number |
PRIO | : Lower No. has higher priority, Equal priority alarms will be serviced repeatedly. |
PRS | : Stored preset number to be called by alarm. |
IN | : NO/NC - normally open /Closed OFF - ignore |
OUT | : OUT1~OUT4 - Relay out 1,2,3,4, OFF - No output. |
HOLD | : Alarm will be held for programmed time (01 to 99 seconds) |
LATCH | : ON - Shows all alarms including past alarm, OFF - Shows activated alarms only. |
There are 8 levels of priority. “0” is the highest priority and can be choosed Autoscan, Pattern or Tour. During responding “0” priority alarm, other alarms won’t be serviced until the “0” priority action is completed.
1.Press Menu to display the main menu on the monitor. Select the Alarm option by pushing the Joystick up or down and push to right to enter the detail menu.
2.Select the alarm input number by pushing the Joystick up or down and select the column you wish to setup. Selected position will be highlighted.
3.Select the Preset, Status of Input (NC/NO/OFF), and Output (OUT1~4/OFF) by pushing the Joystick to the right or to the left.
4.To increase or decrease the preset number or to change the status or output number, twist the Joystick clockwise or counterclockwise. In case of preset, programmed preset number will be scrolled.
5.Select the Save and Exit option by pushing the Joystick up or down. Save and exit the program by pushing the Joystick to the right. Press ESC to exit the program without saving.
18
