ˆInstallation
MOUNTING THE PHONE
You can place the phone on a desk or table, or mount it on a standard wall plate or direct- ly on a wall. Select a location that is:
•near an AC outlet
•near a telephone line jack
•out of the way of normal activities
•away from electrical machinery, electri- cal appliances, metal walls or filing cabi- nets, wireless intercoms, alarms, and room monitors
•away from other cordless phones
The base's location affects the handset's range. If you have a choice of several loca- tions, try each to see which provides the best performance.
Cautions:
You must use a Class 2 power
!source that supplies 9V AC and delivers at least 350 mA.
Its center tip must be set to positive and its plug must fit the phone's
jack. The supplied adapter meets these specifications. Using an adapter that does not meet these specifications could damage the phone or the adapter.
•Always connect the AC adapter to the phone before you connect it to AC power. When you finish, disconnect the adapter from AC power before you dis- connect it from the phone.
Note: Your telephone connects directly to a modular telephone line jack. If your tele- phone wiring does not have a modular jack, you can update the wiring yourself using
jacks and adapters available at your local RadioShack store, or have the telephone company update the wiring for you.
The USOC number of the jack to be installed is RJ11C (or RJ11W for a wall plate jack).
On a Desk, Shelf, or Table
Follow these steps when you place the base on a desk, shelf or table.
1.Insert the bracket’s tabs into the base’s upper tab slots, then press down on the bracket’s clips and insert them into the clip slots.
2.Plug one end of the supplied long modu- lar cord into the TEL LINE jack on the back of the base.
3.Route the modular cord through the strain relief hook.
4.Plug the modular cord's other end into a modular telephone line jack.
5.Insert the supplied AC adapter's barrel plug into the DC IN 9V jack on the back of the base.
6.Route the adapter's cord through the strain relief slot on the bracket.
7.Plug the adapter into a standard AC out- let.
8.Lift the base's antenna to a vertical posi- tion.
8 |
| Installation | ||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
