ASSEMBLY INSTRUCTIONS
L |
R |
STEP 3
NOTE: There is a "L" decal on the LEFT PEDAL SUPPORT(49) attached to the left PEDAL RAIL ASSEMBLY. Attach the left PEDAL RAIL ASSEMBLY to the left side of the Elliptical unit. There is a "R" decal on the RIGHT PEDAL SUPPORT(50) attached to the right PEDAL RAIL ASSEMBLY. Attach the right PEDAL RAIL ASSEMBLY to the right side of the Elliptical unit.
Remove HEX HEAD BOLTS(M8 x 16mm)(74) and LOCK WASHERS(M8)(88) from the RIGHT PIVOT(45). Keep the PEDAL RAIL CONNECTOR(43) on the RIGHT PIVOT(45). Then insert the right PEDAL RAIL ASSEMBLY onto the RIGHT PIVOT(45) and secure with HEX HEAD BOLTS (M8 x 16mm)(74) and LOCK WASHERS(M8)(88). Do not tighten the bolts. Insert the bolt on the PEDAL SLIDER(51) into the hole on the RIGHT PEDAL ARM CONNECTOR(56) and secure with NYLOCK NUT(M10)(86) and WASHER(M10)(90). Tighten BOLTS(M8 x 16mm)(74). Repeat on the left side.
STEP 4: Attach the PEDAL CAPS(46) onto the LEFT and RIGHT PEDAL SUPPORTS(49, 50) with ROUND HEAD BOLTS(M6 x 25mm)(65). Slide the PEDAL DIVIDERS(47) into one of the four slots on the PEDAL CAPS(46) to fit your shoes. You may select the front or the back of the PEDAL CAPS(46) for foot placement. You will have more vertical movement in the Elliptical stride if you place your feet at the back of the PEDAL CAPS(46).
CAUTION: The lip on the PEDAL CAPS(46) must face inside. The sides without a lip face outside as shown.
7
