Federal Communications Commission
Radio Frequency Interference
Statement
Thw rquipment generates and uses radio frequency energy and if not installed and used
properly. that is. in strl~“l accordance Lvith the manufacturer’s instructions, may cause in-
terference to radio and [etexxion reception. It has been type tested and found to comply
with the limits for a Ctavs B computing device in accordance wth the specifications in
Subpart J of Part 15 of FCC Rules, ivhich are designed to provide reasonable protection
against such inrerfcl-ence in a residential installation. Ho~vever. there is no guarantee
that interfrr-ence ~?ll not occur- in a particular installation. If this equipment does ~tuse
interference to radio or telex-ision reception. which can be determined by turning the
equipment off and on. the user is encouraged to try to correct the interference by one or
more of the folk)\\-ing measures:
l Reorient the receiving antenna
oRelocate the computer \vith respect to the receiver
l Slovv the computer away from the receiver
l Ptug the computer into a different outlet so that computer and receiver are on dif-
fercnt branch circuits.
If necessary. the user should consult the dealer or an experienced radioitete\,isiorl techni-
cian for additional suggestions. The user map find the following booklet. prepared h!
the Federal Communications Commission helpful: “Ho\r to Identify and Kesotve Radw
T\’ Interference Prohlrms. ” This hooklet is available from the I’.S. Government
PI-inting Office. LVashington. D.C.. 20402. Stock No. 001-000-00345-4.
For compliance with Federal Noise Interference Standard. this equipment requires a
shielded cable.
Self Declaration
Radio interferences regarding this equipment has heen eliminated according to Vfg
lO-l6/1984 announced hy the DBP.
DBP has been informed about the introduction of this special equipment and has been
conceded the right to esamiw the whole series.
It is upon the responsibility of thv user to assume that his own asscmhted system is in ac
cordance with the technical regulations under Vfg lOltiilYX4.
To observe FTZ-regulations it is necessary. to establish all connections io the printer
\vith shielded cable.
Trademark Acknowledgement
NX-10, grafstar: Star Micronics Co., Ltd.
r\pple, Apple II, ;2pple II - , Apple II e, Applesoft: Apple computer Inc
Commodore C-&l: Commodore Business Slachines. Inc.
Compaq: Compaq Computer Corporation
CI’IM: Digital Research
IBM Personal Computer, IHM LX: International Kusinehs Machines Corp.
Kaypro: Kaypro Corporation
Microsoft Rr\SIC: Microsoft Corporation
Osborne 1 : Osborne Compu~el- Corporation
TRS-80: Radio Shack. a division of Tandy Corporation
NOTICE
l A1l rights reserved. Reproduction of any part of this manual in any form what-
soever, without STAR’s express permission is forbidden.
l The contents of this manual are subject to change without notice.
l All efforts have been made to ensure the accuracy of the contents of this manual at
the time of going to press. However, should any errors be detected, STAR would
be greatly appreciate being informed of them.
l The above notwithstanding, STAR can assume no responsibility for any errors in
this manual.
Topyright 1986 Star Micronics Co., Ltd.