I
I
.
‘,,, ,’
15
5. Flip the clamp levers backward. This allows the two
sprocket units to move freely right and left so you can
align them with the holes in the paper.
6. Feed the end of the paper into the slot next to the platen
cover plate.
7. Fit the holes in the paper over the sprocket pins so the
paper is even, and clamp the sprocket units in place.
8. Check that the paper is still positioned correctly, and
close the sprocket covers (Figure 2-8).
9. The Power indicator should be blinking. Turn the platen
knob to feed the paper until the indicator stops blinking.
10. Now turn the platen knob the other way just a bit, until
the indicator starts blinking again.
11. Set the release lever to the auto-feed setting. The printer
will advance the paper automatically.
12. When the paper stops, set the release lever for sprocket-
feed paper again.
13. Finally, install the paper guide on the printer (Figure
2-8). Now you’re ready to roll!
“igure 2-8. Ready to run with sprocket-feed paper.