– 11 –
ENGLISH
Pause at a: HEX dump
Pause at b: sensor selection
Press ON LINE 1 short beep Reflecting sensor
Press FEED 2 short beeps Transmissive sensor
Pause at c: command mode selection
Press ON LINE 1 short beep Page mode
Press FEED 2 short beeps Line mode
3) Power + ON LINE + FEED switches
(Turn the power on while holding the ON LINE and FEED switches depressed.)
Approx. Approx. Approx. Approx.
2 sec. 2 sec. 2 sec. 2 sec.
1 short beep … 2 short beeps … 3 short beeps … 1 long beep … …
abcde
HEAD UP NO PAPER ERROR LEDs flash All LEDs
LED LED LED successively light up
lights up lights up lights up lights up
Pause at a: RAM backup cleared
Pause at b: feed function selection
Press ON LINE 1 short beep Top of Form disabled.
Press FEED 2 short beeps Top of form enabled.
Pause at c: sensor adjustment mode
Pause at d: no operation
Pause at e: clearing of all memory switches and test print
1At e, release the ON LINE switch and FEED switch in 2 seconds
or less (all LEDs go off).
2Press the ON LINE switch and FEED switch in 2 seconds or less,
and hold them depressed for at least 3 seconds (all LEDs light up).
3Release the ON LINE switch and FEED switch.
4The contents of all memory switches will be erased (all will be set
to 0).
After that, test print is carried out.
* If this process is interrupted midway, the printer will operate in
regular mode.
* After the memory switch settings are erased, the memory switches
must be set again, as appropriate for each model.