– 68 –
APPENDIX
Appendix B: Dip switch setting
DIP switches are located on the interface board. The number of switches varies
according to the board, as follows.
Parallel interface One 4-bit DIP switch
Serial interface One 10-bit DIP switch and one 4-bit DIP switch
The following is the procedure for changing the settings on DIP switches.
1. Make sure the printer is turned off.
2. Remove the screw from the ROM cover. Next take off the ROM cover, as
shown in the illustration below.
3. Set the switches using a pointed tool, such as a pen or flat-blade screwdriver.
4. Replace the ROM cover. Then secure it with the screw.
The new settings take effect when you turn on the printer.
1
ON
OFF DIP switch 1
10 1
DIP switch 2
4
1
DIP switch 1
4
ON
OFF
(Serial Interface)
(Parallel Interface)