– 12 –
ENGLISH
6-3. Print Density Adjustment
Since the sensitivity of different types of heat-sensitive paper varies, you can
adjust the print density by varying the current supplied to the thermal head.
The print density can be adjusted using the variable resistor inside the hole beside
the interface connector on the back of the printer.
1. To adjust the density turn the resistor roughly two times using a small cross-
head screwdriver.
2. Turn the resistor to the right (clockwise) for a darker print density or to the left
(counterclockwise) for a lighter density.
NOTE: If the density is increased to a higher level than necessary when printing
on highly sensitive heat-sensitive paper, the dots may be too large and the
print quality may decrease.
Excessively high energy adjustment may reduce head life.
6-4. Sensor Adjustment Mode
Sensor levels are adjusted at the factory. If necessary, you can readjust the levels
as described below.
Variable resistor used to
adjust the print density
VR4VR2
VR3
VR1
Interface PCB
EPROM
Main PCB