Models Covered, Standard Features | Sterling 6017 series specs

1-3 Models Covered

This manual lists installation, operation, and maintenance instructions for the 6017 Series hot oil large temperature control unit.

Model numbers are listed on the serial tag. A model number followed by -Qindicates a specially constructed unit, and not all information in this manual may apply. Make sure that you know the model number, serial number, and operating voltage of your unit if you contact Sterling, Inc.

1-4 Standard Features

•M2B microprocessor controller with fuzzy logic; includes diagnostic features with indicator and warning status lights

•Non-fused lockable rotary disconnect

•Dual stage immersion heater with IEC contactors

•550°F (288ºC) maximum operating temperature

•Branch fusing

•System status graphic display

•Pressure switch for low pump pressure shut-down

•NEMA 12 electrical enclosure

•UL listed subpanel

•To Process pressure gauge

•Independent safety thermostat

•Y strainer on From Process line

•A packed positive displacement pumps capable of reversing to evacuate the process

•Easily removable panels for quick access to internal components

•Audible alarm

Page 8

6017 Series Hot Oil Large Temperature Control Units

Image 8

Sterling 6017 series installation manual Models Covered, Standard Features

Contents

Series Large Hot Oil Temperature Control Units $30.00 Series Hot Oil Large Temperature Control Units Safety Considerations Table of Contents Startup Preparations Charts and Figures Introduction Necessary Documents Standard Features Models Covered Immersion Heaters Feature DescriptionsAvailable Options Ful-Flo Valve Heater TankPump Optional CoolingConnection Lines Electrical System Controls Electrical Panel and System Components Air Purge Reservoir Tank Pressure SwitchSafety Thermostat Series Hot Oil Large Temperature Control Units 50 kW 100 kW 150 kW 200 kW 90 gpm 150 gpm 200 gpm Lbs Unpacking and Inspection Event of Shipping Damages Returns If the Shipment is Not CompleteIf the Shipment is Not Correct Work Rules Installation RequirementsInstallation Location Considerations Connecting Piping Piping Considerations for Mobile Installations Customer is responsible for conversions to metric standards Connecting Vent Piping Connecting Process PipingConnecting Cooling Water Piping Series Hot Oil Large Temperature Control Units Typical Flow Schematic Custom Process Piping Making Electrical Connections Series Hot Oil Large Temperature Control Units Series Hot Oil Large Temperature Control Units Startup Preparations Starting the Unit Unit START-UP with Autovent Solenoid Series Hot Oil Large Temperature Control Units Shutting Down the Unit Returning Fluid to the Tank Series Hot Oil Large Temperature Control Units Using Controls and Indicators Microprocessor Controller Status Indicators Display IndicatorsIdentifying M2B Controller Panel Components Screen Displays Alarm Indicators Using M2B Controller Keys Motor Fail IndicatorSET Point Key UP Arrow Key Index Key Alarm HI Alarm Key Alarm LO Alarm Key Enter Key Digital Flow Screen Identifying Control Panel SwitchesDisplay Key Mode Select Pump StartPump Stop Vent Cycle Start optional Identifying System Status Board Indicators Alarm Silence Status Indicator Lights Mode Indicator Lights Fault Indicator Lights Auto Mode Indicator LightPump Overload Indicator Light Low Pressure Indicator Light High Level Indicator Light Low Level Indicator Light Series Hot Oil Large Temperature Control Units Making Monthly Checks Periodic ChecksMaking Daily Checks Making Six-Month Checks Routine ServicingMaking Quarterly Checks Servicing the Unit Monthly or Every 500 Hours Servicing the Unit Every Three Months Motor Lubrication Procedure Corrective Maintenance Pumps and Seals Series Hot Oil Large Temperature Control Units Troubleshooting Check the heater output with an Service Notes Service Notes Service Notes Technical Assistance Parts Department