Sterling 6017 series Available Options, Feature Descriptions, Immersion Heaters

1-5 Available Options

•Drain valve

•Manual bypass

•Hour meter; measures total pump run time hours

•General fault visual alarm

•Automatic venting sequence

•Low level alarm for reservoir

•M2B microprocessor controller options include:

„4-20 mA remote set point and retransmission

„SPI protocol, RS-485

„General protocols, types RS-232, -485

„Remote sensor

•Heat exchanger options of

•3.9 sq. ft. (0.3627 sq. m)

•6.7 sq. ft. (0.6231 sq. m)

•13 sq. ft. (1.21 sq. m)

•21 sq. ft. (1.96 sq.m)

•27 sq. ft. (2.51 sq. m)

•Remote controller

•Lexan cover

•Mechanical Seal Pump

•Optional operating voltages of 208/3/60, 230/3/60, 575/3/60, 380/3/50, and 415/3/50

•Provisions for a Nitrogen Blanket on the Reservoir can drastically increase fluid life.

1-6 Feature Descriptions

Immersion Heaters

The fluid is heated by the specially designed three-phase low watt density electrical immersion heater, and regulated by the controller. The standard heater has a steel sheath for low watt density and good heat transfer.

These models can be supplied with 50, 60, 75, 100, 120, 150, and 200 kW low watt density immersion heaters, depending upon the heating needs of the process. All models are built to provide full or partial heat as required by the process and determined by the controller, to provide more precise control.

6017 Series Hot Oil Large Temperature Control Units Page 9