Sterling operating instructions SSK-5 2.2. Set-up, Installation instructions

SM3-615

SSK-5

2.2. Set-up

The arrangement of the hopper loaders may vary depending on the type of de- vice to be conveyed on and the material used. Fastening onto fixed machine throats is provided by means of strap retainers. However, additional support of the hopper loader is necessary if the devices are not sufficiently capable of bear- ing the load.

Mount the hopper loader in such a way that the outlet flap swings in a right-hand angle to the direction of machine movement. Please check during assembly that the admissible bearing loads are not exceeded.

Please check that all connecting points are tight to ensure that the conveying per- formance is not impaired.

It should moreover be observed, particularly if custom produced connecting parts are used, that the material discharged from the hopper loader must neither get into the open nor must it clog the filter surfaces (observe angle of repose!).

F	Do not excessively load inlet nozzle of hopper loader, remove
	hose separately, if necessary!

J L

Assembly

Installation instructions 11