6-3 Quick Start Guide –XSV Venturi Loader

Unpack all parts. Check for the following:

Conveying hopper with level sensor

Control and maintenance unit

Venturi assembly

Vinyl flexible hose

Compressed air hose

Operating instructions

Mount the conveying hopper using the flange provided on its base.

Mount the control module at a location that is readily accessible. Make sure that the compressed air hose and level sensor cable are long enough to reach the control module.

Connect the compressed air supply from the control module to the fitting located on the material pick up wand.

Connect shop compressed air to the regulator on the control module. Compressed air connection must be 70-90 psi (5-6 bar).

Plus the control module into the main power socket. Make sure that the correct voltage is being used.

Adjust the level sensor to sense the material that is being conveyed into the conveying hopper.

Maintain the unit as stated in Chapter 5 of this manual.

XSV-05, XSV-05/R, & XSV-05/2R Single Conveying Units - Venturi Style

35 of 36

Page 36
Image 36
Sterling SSV-052R, SSV-05R operating instructions Quick Start Guide -XSV Venturi Loader