USER INSTRUCTIONS
Air Inlets 
Log Guard
AR2147
• Close the door
Do not leave the door open as this could
5.Running The appliance
5.1Burning Wood:
•Close the Primary air control and use the Airwash to control the burn rate when appliance is at operating temperature, see Diagram 9
•Leave the Secondary Combustion control open The position will vary between half and fully open depending on the flue draught.
Air Wash: Adjust
Secondary
Combustion
Control (not 1A)
Half - Fully open | PR7225a |
|
|
• Wood burns best on a bed of ash
•Rake the embers evenly over the fire bed and open the
Airwash control fully for a few minutes before
5.2Burn new logs at high output for a few minutes before adjusting the Airwash control. Refuel little and often for clean, efficient burning.
5.3Experience establishes settings to suit personal preferences.
5.4Do not burn large amounts of fuel with the Airwash control closed for long periods of time. This reduces the glass cleaning effect and causes tars and creosotes to
5.5When in use, burning the appliance at high output for a short period also reduces tars and creosote.
5.6Burning Solid fuel:
•Set air controls, See Diagram 10
Airwash
25% Open
Primary Air
Fully Open
Secondary |
|
|
Combustion | Closed | |
Control (not 1A) |
|
|
| PR7225a | |
|
|
|
5.7
•Open the Primary air control fully to establish a glowing bed before adding new fuel
•Burn new fuel at high output for a few minutes before adjusting the Primary air control to the desired setting
•Refuel little and often for clean, efficient burning.
5.8Experience establishes control settings to suit personal preferences
5.9Do not burn large amounts of fuel with the Primary Air Control on low settings for long periods of time. This reduces the glass cleaning effect of the airwash and causes tars and creosotes to
5.10When in use, burning the appliance at high output for a short period also reduces tars and creosote.
7
