Manuals / Stovax / Household Appliance / Stove

Stovax P8701CFCHEC, P8700CFCHEC manual Installation Instructions, 4.9METHOD 2 - NO FRAME

Models: 8701CFCHEC P8700CFCHEC P8701CFCHEC 8700CFCHEC

1 33
Download 33 pages 19.71 Kb
Page 19
Image 19
NOTE: To check gas pressure refer to paragraph 4.11

INSTALLATION INSTRUCTIONS

INSTALLATION

•Feed the wires for the remote touch pad through the grommet in the left side of the loose box

The wires are then fed inside the firebox and routed through the available access

•Replace the loose box inside the main firebox ensuring the wires are not trapped

•Replace the three wing nuts and seven screws

•Connect the gas supply and check for leaks

•Replace the rear panel ensuring the bottom edge locates in the tapered brackets, Diagram 29

29

AR1968

NOTE: To check gas pressure refer to paragraph 4.11

•Replace the splitter plate

•Locate the rear two tabs into the rear panel

•Engage the two side slots over the screws and secure,

Diagram 30

30

To replace the burner:

•Locate the left-hand side into the burner bracket

•Lower the right-hand side to engage the injector onto the venturi and also the pilot into the aperture in the burner skin

•Push the burner to the right and engage the burner into the slot in the bracket

•Replace the fixing screw, Diagram 31

31

AR1965

To replace the doors and panels, refer to Replacing Parts, Section 3 and 5

4.9METHOD 2 - NO FRAME

The front of the chimney breast has to be studded and boarded to allow the edge kit to be fitted.

For this cool-wall Edge installation, the convected heat of the fire is channelled into the cavity between the existing chimney and the false wall, then vented at the top. The vent should have a minimum open area of 200mm.

•Proceed as described in Section 4.1 to 4.8, but do not fit the frame brackets

You have now removed the box from the appliance and should use the following:

•Fit the edge kit to the two sides and lower edge using the screws and rawl plugs provided, Diagram 32

32

AR1912

•Stud the face of the chimney breast using the method described in Section 3.3, Diagrams 14, 15.

Do not fix any horizontal stud work above the appliance as this will prevent the convected air escaping through the vents

•Fit the non-combustible board and the plasterboard as described in Section 3.3

•Apply plaster skim to the front of the chimney breast

19

Page 18 Page 20
Page 19
Image 19
Stovax 8701CFCHEC manual Installation Instructions, 4.9METHOD 2 - NO FRAME, NOTE To check gas pressure refer to paragraph
Page 18 Page 20

FAQ

How do I install the remote touch pad?

Feed the wires through the grommet in the left side of the loose box, route them inside the firebox, replace the loose box and secure the wires. Connect the gas supply and check for leaks.

How do I replace the burner?

Locate the left-hand side into the burner bracket, lower the right-hand side to engage the injector onto the venturi and pilot into the aperture in the burner skin. Push the burner to the right, engage it into the bracket slot, and replace the fixing screw.

How do I fit the edge kit for the cool-wall Edge installation?

Stud the face of the chimney breast, fit the non-combustible board and plasterboard, and apply plaster skim to the front of the chimney breast. Then, fit the edge kit to the sides and lower edge using the provided screws and rawl plugs.