How do I change the main injector on my Stovax stove?

To change the main injector, first undo the injector feed pipe and the lock nut from the injector. Then, remove the silencer and replace it with the correct size injector. Finally, check for leaks.

What parts do I need to change when switching between gas types on my Stovax stove?

When changing between gas types, you will need to change the burner unit, pilot control valve, injector, and aeration plate if required. Make sure to order a kit of parts that are available for this process, and always quote the model number and serial number when ordering any spare parts.

Servicing Instructions, Replacing Parts, Main injector

Q: What do I need to do to access the debris area of my Stovax stove?

To access the debris area, you will need to remove the steel frame, glass door assembly, enameled panels, and the burner and splitter plate. Make sure to isolate the gas supply and disconnect the isolating device from the inlet pipe on the appliance. Then, remove the screws from the loose box, rear panel, and wing nuts. Once the box is released, any debris can be removed before replacing the parts in reverse order.

SERVICING INSTRUCTIONS

REPLACING PARTS

13.main injector

13.1To change the main injector:

•Undo the injector feed pipe

•Undo the lock nut from the injector and remove the silencer

•Replace with the correct size injector

•Check for leaks

14.Primary Aeration Plate

NOT ALL MODELS HAVE AERATION PLATES. REFER TO NOTE AT BEGINNING OF INSTALLATION INSTRUCTIONS.

9.1Remove the burner module as described in Replacing Parts Section 6.

9.2Remove the fixing screw and slide the plate off the venturi.

9.3Replace with the correct size plate and secure with the screw. Ensure the lower edge of the plate is located over the venturi flange, Diagram 16.

AR0766

15.DEBRIS AREA ACCESS

•Remove the Steel frame (if fitted)

•Remove the glass door assembly

•Remove the enamelled panels

•Remove the burner and splitter plate

•Isolate the gas supply

•Disconnect the isolating device from the inlet pipe on the appliance

•Remove the seven screws from the front of the loose box, Diagram 17

AR1967

•Remove the three screws from the rear panel

•Lift the panel to disengage the locating brackets, Diagram

•Remove the three wing nuts from the rear of the box,

Diagram 17

To release the box from the main body:

•Rotate the front of the box upwards and draw the box forward off the rear studs

•Ensure the gas pipe passes through the silicon seal in the base of the box

Any debris can now be removed through the aperture.

•Replace in reverse order taking care not to damage the gas pipe when replacing the box

16.Changing between

Gas Types

In order to change between gas types, it will be necessary to change the following items:

Burner Unit

Pilot

Control Valve

Injector

Aeration Plate (if required)

Data badge

A kit of parts is available for this, always quote the Model number and Serial number when ordering any spare parts.

NOTE: THE CONTROL VALVE IS FACTORY PRESET FOR THE CORRECT GAS TYPE AND MODEL, A NEW UNIT WILL NEED TO BE ORDERED WHEN CHANGING BETWEEN GAS TYPES.

Stovax P8701CFCHEC Servicing Instructions, Replacing Parts, main injector, Primary Aeration Plate

Models: 8701CFCHEC P8700CFCHEC P8701CFCHEC 8700CFCHEC