Stovax 8701CFCHEC manual Installation Instructions, Fix foam seal to the outer flange of the fire

INSTALLATION INSTRUCTIONS

INSTALLATION

7

AR1903

•Fit the supplied top support bar into the stud work at the correct height, Diagram 8, because no combustible material can be used above the fire

8

AR1904

NOTE: If a frame is to be fitted, attach the brackets before installing the appliance.

•Attach the 4 frame fixing brackets to the fire, Diagram 9

•Fix foam seal to the outer flange of the fire

9

AR1913

•Position the fire

•Fit non-combustible board to the stud work around the fire This should extend a minimum of 400mm above the appliance and at least 50mm to the sides of the appliance (from the outer box, not the flanges).

For non-combustible area see Diagram 2b.

The remaining area can be finished using plasterboard:

•Apply a plaster finish to the front of the chimney breast

•Secure the fire back to the stud work using four screws through flange, bracket, support bar

•Decide on the position for the wall box containing the batteries and wall switch

•Connect the wire from the fire to the battery pack,

Diagram 10

10

AR1920

•Connect the wire from the fire to the touch pad/ connector, Diagram 11

11

AR1919

•Correctly position the four new AA size batteries

•Re-assemble the battery holder as shown in Diagram 12

•Ensure the touch pad cable is tucked to the left on fitting the wall plate back onto the wall

12

AR1905

•Secure the wall plate with the touch pad attached to the wall box, Diagram 13

15