![](/images/new-backgrounds/1081358/8135821x1.webp)
OVE RLAY PANE L IN STALLAT ION
GL ASSWEL L— DI SPENSER MOD ELS | GR ILLE PANEL AS SEMBLY |
The dispenser area of Models
To remove the glasswell bezel for an overlay/ flush inset Model
Insert the overlay/flush inset panel into the door trim. Reverse the procedure to install the bezel, touch pad and water grille. To install the plastic rivets, insert rivets through the touch pad and into the control housing and secure by pressing mandrels into the body of the rivets. Refer to the illustrations below.
IMPORTANT NOTE: The total panel thickness (including backer and spacer, if used) in the glasswell bezel area can range from 6 mm to a maximum of 29 mm. If the panel is thicker, provi- sions must be made to rout out a space to accommodate the bezel surrounding the glass- well.
Remove the inner grille panel assembly as described in Grille Removal, page 8. Remove the top two corner screws and pull away the top frame. Slide the panel into position in the grille frame. If you are using a grille panel 6 mm or thinner, you will need to install a filler.
Reattach the top frame by reinstalling the two top corner screws. Install the inner grille panel assembly onto the unit, by reversing the proce- dure outlined in Grille Removal, page 8.
Refer to specifications for Overlay Grille Panels on page 12, and the illustration on page 10, for the exact sizing of all three panels.
CAUTION
Do not exceed the panel dimensions listed for the appropriate overlay grille panel you are specifying. The overlay decorative panel cannot be any larger or it may restrict the air flow to the compressor area and cause problems with the operation of the
Lock
Indicator
Touch Pad
Water
Key Pad
Ice
Key Pad
Light
Key Pad
Water
Grille
Bezel
Glasswell— dispenser models | Glasswell bezel removal |
11