Sub-Zero ICBBI-36R SI DE Panel in STA Llation, WO OD SID E Pane LS, Dual Instal Lation S

SI DE PANEL IN STA LLATION

SI DE PANEL IN STA LLATION

IMPORTANT NOTE: Side panels will need to be installed before the unit is placed in its final position.

When installing a Built-In unit with side panels, an accessory side panel kit is necessary. A kit is available for installation of stainless steel side panels and one for installing custom wood side panels. Refer to the instructions with the stain- less steel side panel kit when installing stainless side panels. The following information is in refer- ence to installation of custom wood side panels.

WO OD SID E PANE LS

Routing will be necessary on the side panel in order for it to fit flush against the side of the unit. Refer to the illustration below for routing detail. If you have Model ICBBI-30U, ICBBI-30UG, ICBBI- 36U or ICBBI-36UG, extra routing will be neces- sary to avoid having the panel hit the refrigerator lower hinge plate. The illustration on the follow- ing page points out the areas where extra routing is needed for these models.

Install the brackets provided in the kit onto the side panel in the locations shown in the specifi- cations illustration below. The front brackets are meant to engage the mainframe and the back brackets will wrap behind the unit when the panel is in place. Screws are provided in the kit. If the provided screws will not work for your installation, you will need to provide the neces- sary screws to attach the brackets.

IMPORTANT NOTE: When a side panel is mounted on the hinge side of an over-and-under unit, it will be necessary to move the bottom front bracket down from the location shown in the illustration on the following page to avoid interfering with the hinge plate.

Place the panel at a 75° angle and engage the front brackets into the mainframe. Swing the panel inward, being sure that the front brackets engage the mainframe. With the panel in position, attach the rear brackets to the rear of the unit with the screws provided. Check to see that the panel is secure. Refer to the illustration below.

IMPORTANT NOTE: The use of side panels may change the width of your rough opening.

IMPORTANT NOTE: The overall height on the side panel will vary with the height of the grille being used. Make sure you know your finished height before cutting any panels.

DUAL INSTAL LATION S

When two Built-in units are installed side-by- side, it is necessary to use a Sub-Zero Built-in dual installation kit. Contact your Sub-Zero dealer for the proper components and installa- tion instructions.

IMPORTANT NOTE: Flush Inset panel sizes for dual installations are different than those listed in this book. Please refer to the Sub-Zero Built-In Refrigeration Design Guide.

IMPORTANT NOTE: Dual installations can only be accomplished using two units with opposite hinges.

610 mm FRONT OF UNIT

25 mm
	48 mm
3 mm
13 mm
Main	Side Panel
Frame	Routing

Front
Bracket
	Side Panel
Rear	Main
	Frame
Bracket

	305 mm
146 mm
	108 mm	2032
		mm
2134
mm
	1549
	mm
1353
mm
5 mm DEEP	787
	mm
HINGE SIDE
POCKET
32	521
mm	mm
25 mm
NO SIDE PANEL		102 mm
4 mm	67 mm

48 mm 25 mm

Routing detail— wood side panel	Side panel attachment—
	top view

Side panel specifications

15