Sub-Zero ICBBI-36R, ICBBI-36F Anti -TIP BR AC KET INS Talla Tion, AN TI -TIP Hardw are Included

BUILT-IN INSTA LL ATIO N INSTRU CTI ON S

ANTI -TIP BR AC KET INS TALLA TION

WARNING

Make sure that there are no electrical wires or plumbing in the area which the screws could penetrate.

AN TI -TIP HARDW ARE INCLUDED

2 Anti-Tip Brackets

12#12 x 64 mm PH Pan HD Zinc Screws

410 mm–16 x 95 mm Wedge Anchors

12#12 Flat Washers

4#8–18 x 32 mm PH Truss HD Screws

4Nylon Zip-It Wall Anchors

INS TALL CONC RETE WE DG E ANC HORS

1)Drill a 10 mm diameter hole any depth exceeding the minimum embedment. Clean the hole or continue drilling additional depth to accommodate drill fines. Use a carbide drill bit.

2)Assemble the washer and nut flush with the end of anchor to protect threads. Drive the anchor through the material to be fastened until the washer is flush with the surface material.

3)Expand the anchor by tightening the nut 3–5 turns past hand-tight position or to 34 newton meters of torque.

CAUTION

Always wear safety glasses and use other necessary protective devices or apparel when installing or working with anchors.

Anchors are not recommended for use in lightweight masonry material such as block or brick, or for use in new concrete which has not had sufficient time to cure. The use of core drills is not recommended to drill holes for the anchors.

POSI TION THE UNIT

CAUTION

Protect any finished flooring before moving the unit into place. All Built-In models are equipped with rollers, so you can easily move the unit into place.

Use an appliance dolly to move the unit near the rough opening. Carefully move it off of the appli- ance dolly. Each Built-In unit is equipped with rollers, so it can be moved into position more easily.

Shut off power to the electrical outlet. Plug the power supply cord into the 15 amp grounded outlet and roll the unit into position. Be sure that the anti-tip bracket is properly engaged.

IMPORTANT NOTE: If possible, keep the door(s) closed until the unit is properly anchored.

IMPORTANT NOTE: If for any reason the unit has been laid on its back or side, you must allow the unit to stand upright for a minimum of 24 hours before connecting power.

WARNING

To reduce the possibility of the unit tipping forward, the front leveling legs must be in contact with the floor.

WATER LIN E CON NECTIO N

Approximately .9 m of 6,35 mm plastic tubing is connected to the unit with a preassembled 6,35

mmcompression connection at the end. This tubing is located under the unit.

The water line fitting connection kit, provided with the unit, contains a 6,35 mm compression union fitting for connection to the household water line. Place the compression nut and sleeve on the water line and fasten to the connection at the end of the tubing under the unit. Do not over tighten. Check all water line fittings for leaks. Make sure that the drain pan can be installed or removed without any water line interference.

IMPORTANT NOTE: Be sure to purge the water line prior to final connection to the unit. This will remove any debris that may be present in the tubing from installing the new water line.

IMPORTANT NOTE: Let your customer know that the ice maker will not produce ice immedi- ately, and that the first few batches of ice produced should be discarded. Allow 24 hours for proper ice production.

IMPORTANT NOTE: Caution must be taken not to expose the refrigerator, and/or water lines leading to the refrigerator, to freezing tempera- tures. Failure to do so could cause damage to the product and home.

IMPORTANT NOTE: This appliance should be connected to a potable water supply.

9