Sub-Zero UC-15IO manual Loc Ati On Of Ic E Ma C Hi Ne, Are A Re Q Ui Re M E Nts

SUB- ZE RO ICE MACHINE I NSTA LL AT IO N

LOC ATI ON OF IC E MA C HI NE ARE A RE Q UI RE M E NTS

The location selected for the ice machine must meet the following criteria. If any of these criteria are not met, select another location.

The ice machine may be built into a cabinet, however the location must allow removal of the ice machine for cleaning and servicing. Service diagnostics are performed from the top of the ice machine.

The location must be free of airborne and other contaminants.

Do not place the unit within 18" (457) of a trash compactor or trash/recycling container.

The air temperature must be at least 50°F (10°C), but must not exceed 100°F (38°C) for models UC-15I and UC-15IP and 110°F (43°C) for models UC-15IO and UC-15IPO.

The location must not be near heat-generat- ing equipment.

The location must not obstruct air flow through the kickplate (airflow is in and out the front of the ice machine).

The location must allow enough clearance for water, drain and electrical connections at the rear of the ice machine.

Models UC-15IO and UC-15IPO may be installed outside.

The ice machine must be protected if it will be subjected to ambient tempera- tures below 32°F (0°C). Component failure caused by exposure to freezing tempera- tures is not covered by the warranty. See page 27.

Before moving the ice machine in place, be sure the finished opening dimensions, elec- trical and plumbing locations are accurate. Refer to pages 7–11.

Be sure your plumber, electrician and cabinet installer have this information before finishing work is completed.

Models UC-15I and UC-15IO are gravity drain models that require a drain tube that is pitched down from the outlet at the back of the unit to the sanitary sewer connection. Models UC-15IP and UC-15IPO have a built in drain pump that will pump water up to a drain point, such as a nearby sink. Refer to specifications on pages 8–9.

IMPORTANT NOTE: If the ice machine is installed in a corner, the door swing may be limited due to handle contact with the wall or cabinet face.

IMPORTANT NOTE: The floor under the

ice machine must be at the same level as the surrounding finished floor.

IMPORTANT NOTE: When you move the unit using a hand truck or dolly, position the dolly on the side of the unit and secure the door so it does not open while transporting the unit.

Any finished flooring should be protected with appropriate material to avoid any damage from moving the unit.

6