SUPERSERVER 6015T-T/6015T-INF User's Manual

2-6 Checking the Drive Bay Setup

Next, you should check to make sure the peripheral drives and the SATA drives and SATA backplane have been properly installed and all connections have been made.

1.Check the SATA drives

Depending upon your system's confi guration, your system may have one or more drives already installed. If you need to install SATA drives, please refer to Chapter 6.

2.Check the airflow

Airfl ow is provided by six sets of 4-cm fans (each set of fans consists of two fans that are mounted back to back). The system component layout was carefully designed to direct suffi cient cooling airfl ow to the components that generate the most heat. Note that all power and data cables have been routed in such a way that they do not block the airfl ow generated by the fans.

3.Supplying power to the system

The last thing you must do is to provide input power to the system. Plug the power cord from the power supply module into a high-quality power strip that offers protection from electrical noise and power surges. It is recommended that you use an uninterruptible power supply (UPS) source.

2-10

Page 28
Image 28
SUPER MICRO Computer 6015T-INF, 6015T-T manual Checking the Drive Bay Setup, Check the Sata drives, Check the airflow