SuperWorkstation
6-4 Drive Bay Installation
A total of six SAS or SATA drives may be housed in the
½inch only. Remove by pushing on the open side of the cover to remove it from the chassis (do not try to swing or pull it straight out after opening the left side).
! |
Regardless of how many SAS/SATA drives are installed, all drive carriers must remain in the drive bays to promote proper airflow.
Installing/Removing SAS/SATA Drives
The SAS/SATA drive carriers are all easily accessible at the front of the chassis. These drives are
1.Open the front bezel then push the release button located beside the drive LEDs.
2.Swing the handle fully out and then use it to pull the unit straight out.
Note: Your operating system must have RAID support to enable the
Mounting a SAS/SATA drive in a Drive Carrier
The SAS/SATA drive carriers help to promote proper airflow for the system. For this reason, even carriers without SAS/SATA drives must remain in the chassis.
1.Insert the drive into the carrier with the printed circuit board side facing down so that the mounting holes align with those in the carrier.
2.Secure the drive to the carrier with four screws (see Figure
! |
Enterprise level hard disk drives are recommended for use in Supermicro chassis and servers. For information on recommended HDDs, visit the Supermicro Web site at http://www.supermicro.com/products/nfo/storage. cfm