SuperWorkstation
Manufacture Mode
Jumper JPME1 allows the user to flash the system firmware from a host server to modify system settings. Close this jumper to bypass SPI flash security, and force ME into recovery mode in order to use recovery jump- ers. See the table on the right for jumper settings.
JTAG Scan
The JTAG scan jumpers (JPP0/JPP1) allow the user to configure JTAG scan settings for system debugging. See the table on the right for jumper settings.
SMB Enable/Disable
Jumper JP4 allows the user to enable System Management Bus support. The default setting is
ME Mode Select
Jumper Settings
Jumper Setting Definition
Pins
Pins
JTAG Scan (JPP0)
Jumper Settings
Jumper Setting | Definition | |
Pins 1/2, 3/4 |
| including CPU2 in JTAG Scan |
| ||
Pins 2/3 (Default) |
| JTAG Scan: CPU1 only |
| ||
|
|
|
JTAG Scan (JPP1)
Jumper Settings
Jumper Setting | Definition | |
Pins 1/2, 3/4 |
| including CPU1 in JTAG Scan |
| ||
Pins 2/3 (Default) |
| JTAG Scan: CPU2 only |
| ||
|
|
|
SMB
Jumper Settings
Jumper Setting |
| Definition |
| Enabled (Default) | |
| ||
| Disabled | |
| ||
|
|
|