SUPER MICRO Computer 7047A-T, 7047A-73 user manual Installing Components in the 5.25 Drive Bays

SuperWorkstation 7047A-73/7047A-T User's Manual

Installing Components in the 5.25" Drive Bays

The 7047A-73/7047A-T has two 5.25" drive bays. Components such as an extra floppy drive or DVD/CD-ROM drives can be installed into these 5.25" drive bays.

Removing the Empty Drive Bay

1.First power down the system.

2.Remove the top/left chassis cover to access the drive components.

3.With the cover off, remove the screws that secure the drive carrier to the chassis (one side only) then push the entire empty drive carrier out from the back.

Adding a DVD/CD-ROM Drive

1.Remove the guide plates (one on each side) from the empty drive carrier and screw them into both sides of the DVD/CD-ROM drive using the holes provided.

2.Slide the DVD/CD-ROM into the bay and secure it to the chassis with the drive carrier screws you first removed.

3.Attach the power and data cables to the drive.

4.Replace the top/left chassis cover and restore power to the system.

6-8