OPERATION INSTRUCTION continued
• Use the directional key to move small yellow block selection. When 4 points of yellow block are produced there will be q region wet up for the coverage setting area.
Time insert: "On, Off" are the 2 different status settings. Use the cursor to select and press [Enter] to confirm this function. While "On" selected, a system clock will be shown while recording.
A-7 Housing Setting:
Highlight and select Housings, then press [Enter]for the selection, the
GENERAL SETTINGS | Housing Settings |
|
| |
Record Settings | Channel | Protocol | BaudRate | No. |
Timer Record | ||||
Motion Detection | 1 | 1200 | 01 | |
Alarm Record | 2 | 2400 | 10 | |
Channels | 3 | enkel | 4800 | 25 |
Housings | 4 | 9600 | 63 | |
Network | Return |
|
|
|
Language |
|
|
| |
Exit |
|
|
|
|
Protocol: Using the cursor to select and press [Enter]to confirm difference protocol
BaudRate: Using the cursor to select and press [Enter] select difference rate at 1200/2400/4800/9600;
No: Using the cursor to select and press [Enter] select difference housing number at (01~63).
A-8 Network Setting:
Highlight and select Network, then press [Enter] for this selection, the
GENERAL SETTINGS | Network Settings |
|
Record Settings | IP Address: | 029, 010, 001,100 |
Timer Record | ||
Motion Detection | Subnet mask: | 255,255,255,000 |
Alarm Record | Default gateway: | 029,010,001,254 |
Channels | Transport protocol: | TCP/IP |
Housings | Return |
|
Network |
| |
Language |
|
|
Exit |
|
|
•IP Address: Use the cursor to select and press [Enter]to enter the IP address.
•Subnet mask: Use the cursor to select and press [Enter]to enter the subnet mask at current location.
•Default Gateway: Use the cursor to select and press [Enter] select default gateway according to current IP address.
•Transport protocol: Use the cursor to select and press [Enter] select.
A-9 Language Setting:
Make sure that English is the default setting.
