SVAT Electronics CVDVR900 user manual Motion Detection Setting

OPERATION INSTRUCTION continued

•Date: Select either "Everyday", "Sun", "Mon", "Tue", "Wed", "Thu", "Fri", "Sat" and "Peak", when "Peak" time selected, the device will not use the stand-by function.

•Period 1 and Period 2: Select start time and end time.

Motion Mode: "On, Off" are the 2 different status settings to enable and disable this func- tion respectively. Using the cursor to select and press [Enter] to confirm this function.

A-4 Motion Detection Setting:

Highlight and select Motion Detection, then press [Enter] for this selection, the sub-menu will shown (as below), then select the required area.

GENERAL SETTINGS	Motion Detection
Record Settings	Channel	Effective	Alarm
Timer Record		Region
Motion Detection	1	Settings	On
Alarm Record	2	Settings	On
Channels	3	Settings	Off
Housings	4	Settings	Off
Network	Return
Language
Exit

Effective Region: Use the cursor to select Settings and press [Enter] to confirm this function. Then there will be a region setting screen with full of square grid (as picture shown below), press [Setting] to get the detect area as full screen (all the grid squares will turn a light green square as selected) re-press [Setting] to cancel the selected areas (all grid squares will turn back to clear, and there will be purple flashing cursor right in the centre of screen for selection).

•Using the directional key to move purple cursor for selection. When the grid block being selected (press [Enter] to select), the block will turn light green.

•Cancel with re-press [Enter] key in the block.

•When there are objects moving in the selected region, the block will turn yellow and flashing. (This will activate the recording, if there had been pre-set already).

•Alarm: "On, Off" 2 different status settings. Using the cursor to select and press [Enter] to confirm this function.