OPERATION INSTRUCTION continued
A-5 Alarm Record Setting:
Highlight and select Alarm Record, then press [Enter] for this selection, the
GENERAL SETTINGS | Alarm Record Settings |
| ||
Record Settings | Ch Alarm In_Mode |
| ||
Timer Record |
| |||
Motion Detection | 1 | On | Close | Alarm_Delay: 005s |
Alarm Record | 2 | Off | Open | Out_Delay: 005s |
Channels | 3 | On | Open | Keep_Delay: 005s |
Housings | 4 | Off | Open | Multi_Ch_Rec: On |
Network | Return |
| Multi_Ch_Output: On | |
Language |
|
| ||
Exit |
|
|
|
|
Alarm: "On, Off" are the 2 different status settings available. Use the cursor to select and press [Enter] to confirm this function. While "On" is selected, there will be 16 different task settings for timer setup in each channel (8 different day types, and
2 different period settings available for each type):
Channel 1 Alarm Record Settings
Date | Period 1 | Period 2 |
Everyday | ||
Mon | ||
Tue | ||
Wed | ||
Thurs | ||
Fri | ||
Sat | ||
Peak | ||
Return |
|
|
•Date: Select either "Everyday", "Sun", "Mon", "Tue", "Wed", "Thu", "Fri", "Sat" and "Peak". When "Peak" time is selected, the device does not have the
•Period 1 and Period 2: Available to select the start time and end time.
In_Mode: "Open, Close" are the 2 different input modes for alarm signal input. When the alarm system is set to the "Close" option, when open signal starts, the alarm signal is produced. The input mode in here should be set as "Open".
Alarm_Delay: Key in the number key to setup the time delay (range from 0 to 300 seconds) for alarm recording (default setting as 10 seconds).
Out_Delay: Key in the number key to setup the time delay (range from 0 to 300 seconds) for alarm output (default setting as 10 seconds).
Keep_Delay: Key in the number key to setup time delay (range from 0 to 300 seconds) for alarm warning signal (default setting as 10 seconds).
For example: If an alarm is produced at 23:30:50 the device should start the recording from time 23:30:40 since the system
Multi_Ch_Rec: "On, Off" are the 2 different status settings available. Use the cursor to select and press [Enter] to confirm this function. While "On" is selected, there will be 4 multiple channels interface display as shown below:
