10-11
Configuring the Terminal
3. If the correct hex file is not displayed in the Hex File to Load field, click on the
browse button and navigate to the correct hex file to be downloaded.
4. Click on the Comm Port pull-down menu and select the COM port being used. Ports
already in use display in the Unavailable Ports field.
5. Click on the Baud Rate pull-down menu and select the appropriate baud rate. Your
options are 2400, 4800, 9600, 19200,38400, 57600, 115200.
6. On the Protocol pull-down menu, select None.
Setting Up IPL to Receive the File
To set up IPL on the terminal to receive the files being downloaded via TCM:
1. Cold boot the terminal by pressing the reset button inside the battery compartment
while holding down the Function button.
2. Press and hold the App1 and App4 buttons. While holding down these buttons, press
and hold the battery door switch inside the battery compartment (on the left). This
all must occur within 3 seconds after resetting the terminal.